Interchangeable Chasti-Dick Guide
Skip this if you just want instructions.
The goal is to turn my daily cage, or any for that matter, into a chastidick. I want to be able to wear many cages for different scenes and play. This is the best way I could think to do it without just welding a nut on it and ruining my cage. Not only can I attach a dildo but anything that will screw to 1/4. This might be too complicated to add to the post, but i also got a 1/4” to 3/8” coupling adapter for the future to widen my options
Parts list:
*Silicone RTV (I’m using permatex 80050) you can use 100% silicone too but it wont bond as well. I wanted to be sure and spend way too long in ace trying to find what i needed
*Cage with a hole in it
*Long Bolt for dildo side
*Small half inch bolt to stick out of cage
*Coupling nuts to connect the cage nut to the dildo. THESE ARE AT ACE HARDWARE i could not find them anywhere else
*Regular nuts for small gaps on threads you’d need to fill to get the right size, alternatively you could just leave a big gap inside the coupling nut but i wanted to give the adhesive something extra to hold on to
*Drill bit. I used one half of the bolt and just slammed it in there. The tighter the fit the less likely it is to slide out
Instructions:
Firstly you need a cage and to go to a hardware store to decide what size the hole at the tip is. Just stick some bolt through till you find one that doesn’t wiggle. In my case that is 1/4”. After, buy whatever length bolts fit your dildo. I only had the rod up halfway as I’m using a 7.5” dildo and a 4” bolt. First drill the hole in the dildo. I would be wary of the dildo having a solid core. I didn’t notice until I started drilling but it ended up setting okay. If you are using zinc plated sand down the zinc coating so that the silicone rtv will bond better. Then put on some gloves, clean it with alcohol, fill it with the rtv, and slam it on in there.