u/TechnicianApart8815

This was so comfortable to sleep in; the balls don't get squished at all and i can even lie down on my belly without the cage getting in the way as long as I'm soft. There's not a single position which doesn't work, surprisingly. When im sitting down, the balls might get squished between my legs, but if my legs are closed before I sit down, they don't get squished. I haven't tried it yet, but I'm pretty sure I could ride a bike while wearing this. I don't have any issues while running or while practicing martial arts.

Changes: I made the lock smaller since the v1 lock was way stronger than necessary, made the ring thicker so that it's smoother and more comfortable, changed the dimensions of the cage a little bit, made the peehole bigger (it's still not positioned perfectly so if I make a v3 i'll make sure it lines up with the urethra properly) and I also added holes in the ring to tie a shoelace.

Update: Tried riding a bike, barely felt it there. Morning wood was a bit of a challenge because the erection wouldnt go down until I peed, and it was super messy because the peehole doesn't line up with the urethra. It really seems like the only change I need to make is the peehole placement.

Many of the 3d printed cages still require you to buy some kind of metal lock or use threaded inserts, etc. I wanted to design something that was 100% 3d printed. The lock in this case is made of 100% printable plastic and it can't be taken out without the key. It wont break unless you pull on it extremely hard. Currently, the key is a 3mm allen key, but the key slot could obviously be changed to fit a little 3d printed key. I just had an allen key lying around and metal is pretty good.

Also, the cage is still really comfortable with a foreskin unlike others, which in my experience pinch at the tip, constrict in other ways, or make peeing messier. this is meant to be worn with the foreskin not retracted. For cut people or people who want to wear it with the foreskin pulled back, I think I need to make the glans area a bit smaller. It's still comfortable regardless.

This is V1, so there are still some adjustments to be made.

The ball gap is not an issue. I designed this to be bent with a lighter until comfortable.

If there are any suggestions, please let me know. I can release the .stl files after a bit of refining