Making a custom breast bondage serving tray, need to figure out the tightening system
I'm building a serving tray for use with my wife and I'm trying to think through the mechanics of it.
Above is a rough sketch of the plan. Apologies for the shitty drawing but I'm usually a "do it in my head" builder. The design is that each breast would go on top of the board, between the three holes (maybe four) and then tightened down to secure. The blue rings would connect both to a collar as well as to wrist cuffs. Second best way to take my coffee imho.
Effectively what the problem I'm trying to solve is that the holes back there will be for likely a rope or strap of some kind that I can tighten down on her breasts. I'm also debating some U-bolts instead but I'm unsure.
Two challenges: She has very large, soft breasts, and I want this to be a "strong, constant pressure" not pinching. So my question is what would be the best way to tightly secure her breasts to the board without pinching. I'd ideally like it to be a "slip them in, and tighten it down" type solution as well rather than spending all the time wrapping.