u/drumone59

This was my best Dyna hit in 5 years! Feeling good!

My perf cap clicks very early on this Ti M7 tip, but after timing it out it's a great combo for sure!

I've been heating till the first click, waiting a fuew seconds, then heating past the 2nd click, way past!

This works great, but wondering how others get it done?

This is the NebuluM stem from a fuew years back.

Take a small philips screwdriver and sand it so it,'s not too sharp. Put your regular cap on a wood surface. A light strike on the inside of the cap making a 1/2 mm dent outwards gets it done. It stays on, and I didn't ovalize the regular cap. I used a 50 cent vape screwdriver.

Arriving tomorrow are 2 Ti cap armors, and 1 perforated cap. Which tip would you use the perforated cap with? Thanks! The one on the right is the Nebulum Ti M plus from a fuew years back.

It's so ready to ride the line with this tip! Get one if you can!

I spin it and heat the small dots first, then move to the cap to finish, and it hits as hard or harder than my Armored cap! If you have these give it a try! Use a hefty flame like a scorch torch single.

This was made because 2 lighters failed on me, and shot flames through the vent hole into my hand. So now I use 2 lighters to get to the click to be safe. It's almost as easy as a heater to use. The 2 Scorch lighters, although small have a very strong flame and heat armor perfectly.

After 2 lighters shot flame into my hand, I started using 2! And don't drop your flint flame lock lighter!

I find that the extra room in the tip makes small amounts vape way better.

The 2020 cap on the right is so much better than the new caps, no need to go past the click.

I sanded this 2019 M, still my favorite!