Evergreen 56 Case
Contributing my Evergreen 56 Layout.
For this version, I used 2x 1/2 inch sheets of adhesive back closed cell foam, and an X-Acto knife. The sheets of foam were stacked on top of one another, with different cutouts sets to different heights for each component . The bottom layer only has a cut out for the YLL to allow it to sit deeper into the case, and then the second layer has cut ls out for all of the components.
The layout and use of the Evergreen 56 were great suggestions from other users in the sub.
Two features
of my layout that I think are useful are 1) purposeful notch that allows you to grab the YLL out of a tight form fit hold, which then doubles as a opening to allow for the usb cord to access the YLL without removing it from the case. And 2) the dual depth layer of the foam makes it so the YLL is always tightly held by the evergreen case, even when the reload and tempest case are removed.
I have some access to some high-end 3-D printers, and also a CNC machine through my work. Considering where to take this design next.