▲ 23 r/hzdgrip
Pleasantly surprised but need adjustment
Ordered 26 diameter size 0
Rings 17,18,19 original v2 standard width
My sizing kit I printed on my Bambu A1 had me go with the 26, but the sizing shaft and the actual shaft I ordered aren’t the same size inner diameter. May be a calibration issue with my printer.
18 was the ring size I chose using the test rings and that was initially too large and I could pull the device off. 17 fit well until the middle of the night when it turtled out. I put it back on this morning and all was well till I lifted my leg up to tie my shoe and it slipped off again.
With the difference in size between my test shaft and the product I’m considering going 24 shaft diameter and going -1 length since I’m such a turtler. Any suggestions?
u/Timmeh8604 — 7 days ago