u/No_Boysenberry_9079

should the whole thing go, or just pieces?

when I came, all my puppy juices got on the pillow. smells like me now

can't drive, can't host. kink friendly

at least I had my cage on, so I wasn't feeling too much.

These were constructed out of a sterilite plastic lid, and cut, carved, drilled, and sanded with a dremel. Each one took less than an hour to make. The blue ones are stiffer and thicker. I wear them with a 4 strap harness, but they could be constructed for a 2 or 3 strap harness. Full process below

PHASE 1. Experimentation

Materials/tools: cardboard, scissors, tape (any kind), harness

Start with cardboard. I always start with something simple and cheap. Cut out a notecard sized rectangle. Trim the corners and cut harness slats. I needed to reinforce with tape during this. Is it too long? Too short? Narrow? Wide? I kept making new shields with the cardboard until I found a shape/size that worked for me. My preferred size is 2x6 inches, with trimmed corners, almost ovoid.

PHASE 2. FIRST DRAFT

Materials/tools: scrap plastic (like a Tupperware container, plastic box, something like that. Just make sure it's clean and flat.), drill/dremel (drill bit, sander, and cutting wheel attachments), sandpaper/sanding block, harness

I took the cardboard shield and traced it onto the plastic. I cut out the shape with scissors or Dremel. I made sure to grind the corners and sand the sides. You may have to slightly change the measurements, especially if the plastic is very stiff. I had to, specifically I had to widen the harness slats. Since this will be harder to repair, I suggest drawing a ¼ inch border around the edge and keeping every cut inside it for best results. Continue experimenting. This step is mostly “how to work with plastic/a drill/a dremel” than anything else.

PHASE 3. FINAL

Materials/tools: see phase 2, add final material

Acquire stiffer, stronger plastic. I was working with a lid, and converted it to a flat sheet. When I picked a lid, I made sure it's as flat and smooth as possible. I traced my favorite of the shields onto the plastic and cut it out as usual. I was sure to sand well. You may need to make your harness slats wider so you can attach it properly. I had to

And I was done!

Made myself some cages and been very productive! The rules I have for myself require cage removal for the bathroom, the shower, and work, and as I please for sleep. I was good last night, but touched in the morning :(. Maybe I *should* wear it to sleep. I got home from work all wired up (I typically masturbate to orgasm in the evenings), but I put my cage on and calmed right down. It was nice! TBH, I wish I had an IRL Dom to keep me calm and contained. My "pleasure parts" are in reference to other people's pleasure, and I'm training myself to act like it.

I think this is my first day in years where I had the opportunity to masturbate to orgasm and didn't take it

trans Man, he/him only please!

first time trying chastity and I'm really enjoying it! I was horny at work (wasn't wearing my cage) came home, caged and calmed right down! still humping pillows, but not as much, and I can't leave marks as much

bonus in my chastity

it's fun to try to play with my puppy parts and just feel smooth plastic

these are all made out of a plastic container, cut into a 2x6 rectangle with the corners rounded. they were carved, drilled, and ground with a dremel, and also constructed with a sanding block and scissors. the first two are meant for shielding, and the last is meant to hold outer labia out of the way, for exposure. they're comfortable ish to wear. I could make them narrower. I definitely prefer the diamond dots to the slats. I feel the slats allow too much contact. i haven't tried the exposure oval yet, it's a little hard to change shields with that harness.